Arietta AGR628SS Bedienerhandbuch

10BCDAA.Screws-3.5x9.5mmflat-head(4)B.Faceplate(30”x12”[76.2cmx30.5cm]shown)C.Cabinet(30”x12”[76.2cmx30.5cm]shown)D.Scre

12Replacing the halogen lamp (ARG628SS models) CAUTION: Before replacing the lamps, disconnect power off to prevent from being switched on accidentall

13WARRANTYELICA North America TWO-YEAR LIMITED WARRANTYTO OBTAIN SERVICE UNDER WARRANTYOwnermustpresentproofoforiginalpurchasedate.Pleaseke

3WARNING: TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: Use this unit only in the manner intended by the

4Tools and PartsGather the required tools and parts before starting installation.Read and follow the instructions provided with any tools listedhere.T

5Installation Clearances A.12”(30.5cm)min.upper cabinet heightB.30”(76.2cm) cabinet opening width*C.24”(61cm)min.36”(91.4cm)suggested

6Venting MethodsThis range hood is factory set for venting through the roof orthrough the wall. You can apply the recirculating venting method by purc

7Installation InstructionsPrepare Location It is recommended that the vent system be installed before the range hood is installed. Before making c

8Venting Outside Through the RoofMeasure and mark the lines as shown. Use a saber saw orkeyhole saw to cut an opening through the top of the cabinetan

9Complete Preparation3. Ifnotyetattached,installthe6”(15.2cm)venttransitionthetop of the range hood liner using two 3.5 x 9.5 mm screws.4.